The learner will identify turning tool materials and the cutting conditions associated with turning.
The greatest drawback to brazed carbide tooling is:
The greatest drawback to brazed carbide tooling is:
The re-sharpening expertise that is required
The greatest drawback to brazed carbide tooling is:
The re-sharpening expertise that is required
When we measure the speed on the workpiece at the cutting point, it is known as:
When we measure the speed on the workpiece at the cutting point, it is known as:
Cutting speed
When we measure the speed on the workpiece at the cutting point, it is known as:
Cutting speed
The feed rate in turning is typically measured in:
The feed rate in turning is typically measured in:
FPR
In a facing operation where the tool is feed in toward the center of the workpiece, the cutting speed will ______ continually if the spindle RPM is at a fixed RPM.
In a facing operation where the tool is feed in toward the center of the workpiece, the cutting speed will ______ continually if the spindle RPM is at a fixed RPM.
Decrease
In a facing operation where the tool is feed in toward the center of the workpiece, the cutting speed will ______ continually if the spindle RPM is at a fixed RPM.
Decrease
In an internal grooving operation where the tool is feed out toward the outside of the workpiece, you want the spindle RPM to:
In an internal grooving operation where the tool is feed out toward the outside of the workpiece, you want the spindle RPM to:
Decrease
In an internal grooving operation where the tool is feed out toward the outside of the workpiece, you want the spindle RPM to:
Decrease
Number of tools that can be mounted
Number of tools that can be mounted
In the chip-forming process, which material is likely to form a discontinuous chip?
In the chip-forming process, which material is likely to form a discontinuous chip?
Cast iron
In the chip-forming process, which material is likely to form a discontinuous chip?
Cast iron
Rake angle
Rake angle
Sparking in the cutting zone during a turning operation is usually evidence of _______ wear.
Sparking in the cutting zone during a turning operation is usually evidence of _______ wear.
Abrasion
Sparking in the cutting zone during a turning operation is usually evidence of _______ wear.
Abrasion
Diffusion wear is a product of:
Adhesion wear occurs:
Adhesion wear occurs:
At low temperatures in the cutting zone
At high temperatures in the cutting zone
You have answered 5 of 10 questions correctly.
50%