The learner will show an understanding of feed, speed, surface finish, and conventional milling.
All of the above
All of the above
Higher speed and lower feed than turning
Higher speed and lower feed than turning
The machine is “loose”
The machine is “loose”
All of the above
Which insert corner configuration should produce the best finish if all three options are being run at the same speed?
Which insert corner configuration should produce the best finish if all three options are being run at the same speed?
A very large wiper radius
Which insert corner configuration should produce the best finish if all three options are being run at the same speed?
A very large wiper radius
Climb mill, one-fourth of the cutter should overhang the edge of the part, and use a cutter with a lead angle
Climb mill, one-fourth of the cutter should overhang the edge of the part, and use a cutter with a lead angle
You have answered 5 of 10 questions correctly.
50%