In an internal grooving operation where the tool is feed out toward the outside of the workpiece, you want the spindle RPM to:

The feed rate in turning is typically measured in:

When we measure the speed on the workpiece at the cutting point, it is known as:

Sparking in the cutting zone during a turning operation is usually evidence of _______ wear.

The greatest drawback to brazed carbide tooling is:

Adhesion wear occurs:

In the chip-forming process, which material is likely to form a discontinuous chip?

Diffusion wear is a product of:

In a facing operation where the tool is feed in toward the center of the workpiece, the cutting speed will ______ continually if the spindle RPM is at a fixed RPM.