In this learning activity you'll explore units of measurement.
Calculating Force for Punching
By Dave Hoffman
Users calculate the tonnage required to punch holes in a specific base metal. The formula to be used is provided along with the tensile strength for various metals. A calculator is required.
Safety - Hydraulic Iron Worker
In this learning activity you'll review safety considerations for persons using a hydraulic iron worker and takes a short quiz.
Lathe Project: Tapers & Radii - Index Pin
By Kelly Curran
This project gives a drawing with steps to complete the activity.
Zero Acceptance Number Sampling Plans, c=0
By John Stewart
In this interactive object, learners read about sampling plans and practice using a sampling table.
Measuring Length in the Metric System
By Nabila Dahche
In this learning activity you'll explore how units in the metric system are related to each other and practice locating measurements on a metric line.
Electrical Units, Abbreviations, and Symbols
By Patrick Hoppe
In this learning activity you'll read introduction to electrical quantities, units, and symbols and test their knowledge in a matching exercise.
Reading Indicator Quiz
By Barbara Anderegg
In this learning activity you'll test your skill at reading indicators.
Pneumatic FRL Units
By Terry Bartelt
Learners examine a Filter-Regulator-Lubricator (FRL) unit that is used to prepare the air in a pneumatic system.
How Small Is a Millionth of an Inch?
In this learning activity you'll determine the measurement to be made and the accuracy required.
ორნიშნა რიცხვები - Two-digit Numbers
რიცხვების შედარება; ოცეული,ათეული,ერთეული.
Unit Conversion in the English Measurement System: Area
You'll practice converting between units of measure for area in the English Measurement System.
Standard Form and Word Form Math
Match the word form to the standard form.
Creative Commons Attribution-NonCommercial 4.0 International License.
Learn more about the license »