The Six-Axis Robot
By cebery
The learner will view videos showing the movements of each axis of the six-axis robot.
How Small Is a Millionth of an Inch?
By Barbara Anderegg
In this learning activity you'll determine the measurement to be made and the accuracy required.
Angular Measurement Review
By Kelly Curran
In this learning activity you'll test your knowledge of angular measurement in this 10-question quiz.
Types of Motion Instructions
The learner will identify the types of motion instructions used for programming a robot.
Karnaugh Maps
By Patrick Hoppe
Learners examine the Karnaugh map for a three-variable system. Several examples are given.
Cutting Tapers using the Taper Attachment
This video will show you how to setup and cut a taper using a taper attachment.
Metric Micrometer Measurements Review
In this learning activity you'll review how to read a metric micrometer and use your knowledge to answer 12 questions.
Zero Acceptance Number Sampling Plans, c=0
By John Stewart
In this interactive object, learners read about sampling plans and practice using a sampling table.
Pascal's Law and Hydraulics
By Terry Bartelt
Using the principle of Pascal's Law, the learner will interpret the gauge readings in a hydraulic system to determine when the system is operating properly under various load conditions and when there is a defect.
Using a Sine Bar
By Janet Braun
The learner will use the deceptively simple sine bar to measure angles to minutes or even half minutes.
Avoiding Singularity
The learner will identify components of a welding robot and determine if the robot is set up correctly to avoid singularity.
The Strain Wave Gear Principle
The learner will understand the inner workings of the strain wave gear principle.
Safety Scene - Grinding Edition
By Jessie Jelinski
In this learning activity you'll recognize potential safety hazards around grinding equipment
Hexadecimal Numbering System
In this learning activity you'll review the hexadecimal numbering system.
Digital Circuit Devices
The two types of digital devices, logic gates and flip-flops, and the types of basic operations they perform are presented.
The Cycloidal Gear Drive
The learner will gain an understanding of the inner workings of the cycloidal gear drive while watching a video and listening to an explanation of its features.
Print Reading: Three-Step Block
Learners test their ability to visualize a three-step block in this interactive exercise that features animated pictorial views.
Three-Wire Sensors
By Terry Bartelt, Terry Fleischman
The learner will understand how to correctly wire a three-wire sinking and sourcing sensor.
Safety Scene - Welding Edition
In this activity you'll identify several hazards in a welding environment.
The MOD 10 Counter
The technique for designing a MOD 10 counter is introduced. Asynchronous inputs of a JK flip-flop are used to clear the counter.
Improving Your Welding Technique
Learners will follow general tips and tricks for improving their basic welding technique.
Using Gage Blocks: Discussion and Quiz
In this learning activity you'll identify the consequences of using gage blocks incorrectly.
Equivalent Gates/Ladder Logic Circuits
Learners will identify ladder logic diagrams and the logic functions they perform.
Following Instructions
By Andrea Krabbe
The learner will understand the importance of following instructions.
Darex Model SP2000 Drill Sharpening Machine
By Mike Cattelino
Learners view step-by-step instructions for how to set up and sharpen a drill bit in the Darex drill grinder, model SP2000.