In this interactive object, learners demonstrate the proper tightening sequence for mechanically joining two mating surfaces.
Picture of Adira hydraulic shear's operator's panel with part identification and instructions on how to start and stop the shear as well as setting stroke (cutting length).
Students read how to calculate feed rates for drills in inches per minute (IPM). The IPM formula is given and students work two practice problems.
The student is shown and then identifies the parts of a hydraulic shear.
Introduces two methods of determining bend allowance; one is simple and is an approximate, the other is more precise. Interactive part has learner calculate bend allowance and blank size.
The learner reads about safety considerations for operating a hydraulic metal shear. Text, graphics and a brief assessment are included.
In this learning activity you'll review safety considerations for persons using a hydraulic iron worker and takes a short quiz.
In this learning activity you'll review safety considerations for using a tubing/pipe bender.
In this learning activity you'll review safety considerations for using hydraulic press brakes.
In this simulation, learners follow a series of steps to operate the Marvel Saw PCII in the manual mode. This activity includes a video clip.
In this simulation, learners follow 10 steps to program a job to saw metal. This activity includes a video clip.
Learners are asked to control the Adira press brake following the same steps they would if working on the actual machine.
In this learning object you'll become familiar with the Hurco Controller in full CNC mode.
In this learning activity you'll review the parts of a three-roll power roller and practice identifying them.
In this learning activity you'll explore the control panel of a Marvel 460A-PC vertical band saw and learn how to make a simple cut.
The student reads about the parts of a pipe/tubing bender and later identifies them in an interactive review.
In this interactive object, learners follow steps to program and operate the Ercolina Top Bender.
Students take a quiz to test their knowledge of surface finish.
Students review how to use chordal distances to locate bolt hole circle locations. They then take a 10-question quiz to test their knowledge.
This review tests the student's knowledge of drill press accessories and procedures.
In this document you'll review lathe safety rules.
This document gives an overview of the construction of a lathe.
This document gives an overview of lathe maintenance.
This document gives an overview of lathe lubrication.
This document gives an overview of chuck maintenance.