The learner will convert various values to engineering notation.

Learners alter circuit variables and view how these changes affect circuit voltage, current, reactance, impedance, and phase angle.

In this learning activity you'll explore various ways to calculate the power consumed in a series/parallel circuit.

In this animated activity, students view a step-by-step approach of how to connect an ammeter to a circuit. A brief quiz concludes the lesson.

In this learning activity you'll review how to read a metric micrometer and use your knowledge to answer 12 questions.

Using the principle of Pascal's Law, the learner will interpret the gauge readings in a hydraulic system to determine when the system is operating properly under various load conditions and when there is a defect.

The learner will use the deceptively simple sine bar to measure angles to minutes or even half minutes.

Students complete 10 practice problems.

In this teaching and learning aid, the user can alter circuit variables and view how these changes affect circuit voltage, current, reactance, impedance, and phase angle.

The learner will identify components of a welding robot and determine if the robot is set up correctly to avoid singularity.

The learner will understand the inner workings of the strain wave gear principle.

In this animated object, learners examine how current, voltage and the discharging capacitor of a series RC changes during 5 time constants. A brief quiz completes the activity.

In this interactive activity, students read about the colored stripes on a resistor and interpret the placement of those colors to determine the value of four-band resistors.

Students work nine practice problems to determine the total inductance of a parallel circuit. Immediate feedback is given.

In this animated and interactive object, learners examine a depiction of how force is multiplied by a larger cylinder when pressure from a pump is applied to a smaller cylinder. A short quiz completes the activity.

Learners read a description of the wiring configuration of a residential Edison Wire System, which consists of a transformer secondary circuit. The circuit supplies two 115-volt sources and one 230-volt source.

In this learning activity you'll read the steps for proper meter placement for the measurement of resistance, voltage, and current.

Learners examine an animated view of the operation and programming requirements of a PLC Examine-On instruction. A brief quiz completes the activity.

In this learning activity you'll recognize potential safety hazards around grinding equipment

Learners examine the ways in which a motor starter circuit is protected by a main circuit breaker and overload heaters when there is excessive current.

In this animated activity, learners examine the operation of a dynamic braking circuit used to quickly stop a motor.

Students read about the four steps to creating an ac model and view examples.

In this animated and interactive object, learners examine the voltages that develop across two series zener diodes, which are connected in opposite directions, when DC and AC voltages are applied across them. A brief quiz completes the activity.

In this learning activity you'll review how an open in a series circuit affects current.

Learners examine the changes in current and voltage values in a parallel circuit when open and short conditions develop. Ohm's Law calculations are shown, and a brief quiz completes the activity.