Students read about the basics of using an indicator.

Students read how to determine the total impedance of a parallel circuit using complex numbers. The "J" term is used in the calculations.

In this interactive and animated object, learners apply the Law of Cosines to determine forces using a TI-86 calculator.

Learners apply the Law of Cosines to determine forces using a TI-36X calculator in this animated object.

This primer introduces the student to the correct method of using the internal memory of a TI-86 calculator.

In this learning activity you'll practice using the keys on the Casio fx-260 Solar Calculator.

In this learning activity you'll examine the terms associated with a grouped frequency distribution and follows the steps to construct a grouped frequency distribution using manual methods.

Walk through of how using an inside micrometer for measurement.

This primer introduces the student to the correct method of using the log function on a TI-86 calculator.

In this interactive and animated object, learners apply the Law of Sines to determine forces using a TI-86 calculator.

This video shows how to measure the inside diameter of a part using telescoping gages.

In this learning activity you'll identify the consequences of using gage blocks incorrectly.

In this learning activity you'll review and practice using "they're," "there," and "their" correctly.

In this video, you’ll explore how to calculate, setup, and cut a taper using the tailstock offset method.

This video shows how to measure a hole diameter of a part using small hole gages.

Students view examples of the correct usage of the verbs "lie" and "lay." They then practice using the verbs in a brief exercise.

In this learning activity you'll review the rules for using commas to divide nouns written in a series and complete an activity.

In this learning activity you'll discover how to evaluate a problem statement using both the MEA and the IP Techniques.

In this learning activity you'll calculate percentages using a grid to solve problems.

In this video, you’ll explore how to set up the chuck, face your part using a left-handed and right-handed tool, center drilling, and facing the part to length.