Test your skills at reading a ruler.
Programming Hurco Controller – CNC
By Dave Hoffman
In this learning activity you'll practice operating the Hurco Controller in the CNC mode.
By Terry Bartelt
Instructions on how to use and construct a truth table for digital devices are provided.
Layout Project : V-Block Clamps
By Kelly Curran
In this learning activity you'll review a drawing and steps to complete an activity.
The Electrician's Wheel of Laws Quiz
By James Bourassa
Learners test their knowledge of the variations of Watt's Law and Ohm's Law with this quiz.
Everyone Knows How to Use a Ruler, Right?
By Barbara Anderegg
Students review the best practices for using a ruler and answer five basic questions.
Dial Caliper Measurement Review
You'll practice reading dial caliper measurements.
Measuring with a Dial Caliper
You'll practice identifying measurements on a dial caliper.
Unit Conversion in the Metric System: Area
You'll practice converting units of measure for area in the metric system.
Creative Commons Attribution-NonCommercial 4.0 International License.
Learn more about the license »