Warning! This learning object uses Adobe Flash and your browser does not support Flash. To view this content you will either need to install and/or enable flash in your web browser or upgrade your web browser.
Click Here for instructions to enable Flash.
In this interactive object, learners adjust the caster of a vehicle to control its directional stability.
Engine Testing: Cylinder Compression
By Kevin Guthrie
Students view step-by-step instructions for testing cylinder pressure.
The Primary Flight Controls of an Airplane
By Priscilla Ralls, Jared Huss
In this interactive object, learners experience how the three primary flight controls allow a pilot to determine the motion of the airplane during flight.
Automotive Electrical Systems: Ohm's LawPractice Problems #2
By Andrew Rinke, Patrick Hoppe
Learners review Ohm's Law and then work 12 problems to help them apply the law to automotive electrical systems. In each of the problems, students are given two of the three variables (voltage, resistance, or current) and are asked to solve for the third.
The 8 Wastes of the Lean Production System
By Janet Braun
The learner identifies ways to eliminate or minimize wastes found in business processes. A quiz completes the activity.
Analyze a Part Drawing
By Glenn Sokolowski
In this interactive object, learners answer 25 questions regarding part or assembly drawings. The basic areas of blueprint reading are covered.
Everyone Knows How to Use a Ruler, Right?
By Barbara Anderegg
Students review the best practices for using a ruler and answer five basic questions.
By Kelly Curran
In this learning activity you'll review angles and different types of angular measuring tools associated with manufacturing.
Standard-Position Angles and Reference Angles
By Kevin Ritzman
The learner will recognize standard-position angles and find the reference angle for any standard-position angle.
Horizontal Curve Components
By Steve Whitmoyer
Learners view a horizontal curve and mouse over the diagram to read descriptions of its components and related equations.
I would recommend showing the installation of the wheel with a torque wrench not an impact.
Otherwise it was good.
Creative Commons Attribution-NonCommercial 4.0 International License.
Learn more about the license »