Walk through of how using an inside micrometer for measurement.

This video will walk through the setup and operation of an upright Drill Press.

Learners examine the operation of five pneumatic animated circuits that use directional control valves, pilot lines, check valves, needle valves, and cylinders.

This video will demonstrate angle turning with a compound rest on an engine lathe.

Learners examine the characteristics of a sine wave and the various ways to describe it including Vp, Vp-p, Vrms, Vavg, and frequency.

You will be guided through doing a precision layout a part from a drawing.

This video will demonstrate proper grinding procedures for grinding a twist drill on a grinder.

This video will demonstrate working with independent chucks on an engine lathe.

In this animated object, learners examine how PLC up/down-counters are used to control an automated parking lot gate.

Learners examine the basic types of dimensioning including unidirectional and aligned systems, and linear, aligned, angled, arrowless, chain, datum, chart, tabular, radius, diameter, typical, and reference dimensions.

This interactive object is designed to help learners memorize schematic symbols used in pneumatic diagrams. Learners quiz themselves using electronic flashcards.

In this simulation activity, an electrician will troubleshoot an AC motor that is overheating. Before accessing blueprints and then using a multimeter to find the fault, the learner will follow safety protocols by following lock-out tag-out procedures and then suit up with appropriate (PPE) personal protection equipment.

In this animated object, learners examine how to align a part on the 1808 CMM.