In this learning activity you'll follow 11 steps to take measurements using a Vernier caliper.

Learners follow the steps required to perform the Ziegler-Nichols reaction curve process identification procedure.

Learners read an explanation of how to connect two 7485 ICs to compare binary numbers by creating an 8-bit comparator. Diagrams and charts are presented.

In this learning activity you'll review step-by-step instructions for the Marvel PCII using manual programming.

This activity is a simulation that allows the learner to practice personal protective equipment tasks.

This activity is a simulation that allows the learner to practice personal protective equipment tasks.

In this simulation activity, an electrician troubleshoots a defective compressor motor that will not start. To find the problem, the learner selects the appropriate blueprints that must be referred to while performing the troubleshooting steps. Then safety protocols will be followed, such as making lockout-tag out installations and donning PPE items before taking measurements with a multimeter to locate the faulty component.

In this simulation activity, an electrician troubleshoots a defective water pump that will not start. To find the problem, the learner selects the appropriate blueprints that must be referred to while performing the troubleshooting steps. Then safety protocols will be followed, such as making lockout-tag out installations and donning PPE items before taking measurements with a multimeter to locate the faulty component.

In this interactive object, learners read the common abbreviations used in engineering drawings and then test their knowledge in three short exercises.

Conservation of Energy